Department of Transportation June 2007 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation Model 390 Airplanes. This proposed AD would require you to inspect the starter-generator to determine the serial number (S/N) and suffix letter, which indicates if the part is defective, and replace any defective starter-generator with one of new design. This proposed AD results from reports of a manufacturing error where certain starter-generators may have been improperly shimmed. We are proposing this AD to detect and replace defective starter-generators, which could result in premature starter- generator failure. This failure could lead to increased chances of dual starter-generator failure on the same flight.

This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.

The Surface Transportation Board will hold a public hearing beginning at 9 a.m. on Wednesday, July 18, 2007, in the Ground Floor Conference Room of the Richard Bolling Federal Building, 601 East 12th Street, Kansas City, MO 64106. The purpose of the public hearing will be to examine issues related to the efficiency and reliability of rail transportation of resources critical to the nation's energy supply, including coal, ethanol, and biofuels.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This notice proposes special conditions for the Boeing Model 787-8 airplane. This airplane will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. These novel or unusual design features are associated with carbon fiber reinforced plastic used in the construction of the fuselage. For these design features, the applicable airworthiness regulations do not contain adequate or appropriate safety standards for impact response characteristics to ensure survivable crashworthiness. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards. Additional special conditions will be issued for other novel or unusual design features of the Boeing 787-8 airplanes.

This notice proposes special conditions for the Boeing Model 787-8 airplane. This airplane will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. These design features include wing fuel tanks constructed of carbon fiber composite materials. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards. Additional special conditions will be issued for other novel or unusual design features of the Boeing Model 787-8 airplanes.

FMCSA amends its regulations concerning parts and accessories necessary for safe operation in response to a petition for reconsideration filed by the Truck Manufacturers Association. As requested by a petitioner, this amendment resolves an inconsistency between FMCSA's Federal Motor Carrier Safety Regulations and the National Highway Traffic Safety Administration's Federal Motor Vehicle Safety Standards.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is superseding an existing airworthiness directive (AD), which applies to certain Boeing Model 747 airplanes. That AD currently requires repetitive inspections to detect cracks and/or corrosion of the girt bar support fitting at certain main entry doors (MED), and repair or replacement of the support fitting. The existing AD also provides for various terminating actions for the repetitive inspections. This new AD requires the following additional actions: An inspection, for certain airplanes, for correct installation of square and conical washers in the girt bar support fitting; an inspection, for certain other airplanes, to determine if the washers are installed; and related investigative and corrective action if necessary. This AD results from a report that the square and conical washers may be installed incorrectly in the girt bar support fitting on airplanes on which the support fitting was repaired or replaced in accordance with the requirements of the existing AD. We are issuing this AD to detect and correct corrosion of the girt bar support fitting, which could result in separation of the escape slide from the lower door sill during deployment, and subsequently prevent proper operation of the escape slides at the main entry doors during an emergency. We are also issuing this AD to detect and correct incorrect installation of the square and conical washers in the girt bar support fitting, which could result in failure of the escape slide when deployed.

We are adopting a new airworthiness directive (AD) that supersedes AD 2006-23-02, which applies to certain Hawker Beechcraft Corporation (HBC) (Type Certificate (TC) No. 3A20 and TC No. A24CE formerly held by Raytheon Aircraft Corporation and Beech) Models C90A, B200, B200C, B300, and B300C airplanes. AD 2006-23-02 currently requires you to inspect the flight controls for improper assembly or damage, and if any improperly assembled or damaged flight controls are found, take corrective action. Since we issued AD 2006-23-02, we have determined the need to add airplane serial numbers that were not previously included in the applicability. Consequently, this AD retains the actions of AD 2006-23-02 and adds airplane serial numbers to the applicability. We are issuing this AD to detect and correct improperly assembled or damaged flight controls, which could result in an unsafe condition by reducing capabilities of the flight controls and lead to loss of control.

This notice announces actions taken by the FHWA that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to various proposed highway projects in the State of Alaska. Those actions grant approvals for the projects.

The FAA is issuing this notice to advise the public of a meeting of the RTCA Program Management Committee.

The FHWA has forwarded the information collection request described in this notice to the Office of Management and Budget (OMB) for approval of a new information collection. We published a Federal Register Notice with a 60-day public comment period on this information collection on March 9, 2007. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.

FMCSA announces its decision to exempt seventy-three individuals from its rule prohibiting persons with insulin-treated diabetes mellitus (ITDM) from operating commercial motor vehicles (CMVs) in interstate commerce. The exemptions will enable these individuals to operate CMVs in interstate commerce.

The Federal Transit Administration invites public comments about our intention to request the Office of Management and Budget's (OMB) approval to renew the following information collection:

This notice announces action taken by the FHWA and Other Federal Agencies that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to the proposed U.S. 31 Kokomo Corridor highway project, in the Counties of Howard and Tipton, State of Indiana. This action is the Record of Decision issued by FHWA for the U.S. 31 Kokomo Corridor Project.

This action amends the following four Offshore Airspace Areas in Alaska: Norton Sound Low, Woody Island Low, Control 1234L and Control 1487L. This action describes the airspace west of 160[deg] W. longitude as it is currently depicted on aeronautical charts. Some of the existing controlled airspace is described as domestic Class E5 airspace around Kodiak, AK. This airspace instead will be listed within the Woody Island Low Offshore Airspace Area. The FAA is taking this action to provide additional controlled airspace for aircraft instrument flight rules (IFR) operations, and to correctly describe the existing offshore airspace areas in FAA Order 7400.9P, Airspace Designations and Reporting Points, dated September 1, 2006, and effective September 15, 2006.

The FMCSA announces additional details about the initiation of a project to demonstrate the ability of Mexico-domiciled motor carriers to operate safely in the United States beyond the commercial zones along the U.S.-Mexico border. On May 1, 2007, FMCSA published a notice in the Federal Register announcing its plans to initiate the project as part of the Agency's implementation of the North American Free Trade Agreement (NAFTA) cross-border trucking provisions. In response to section 6901(b)(2)(B) of the ``U.S. Troop Readiness, Veterans'' Care, Katrina Recovery, and Iraq Accountability Appropriations Act, 2007,'' FMCSA provides for public comment certain additional details concerning the demonstration project. The FMCSA will carefully consider all comments received in response to the May 1, 2007, notice and this supplemental notice before further decisions are made concerning the implementation of the NAFTA trucking demonstration/pilot project.

On April 19, 2007, the FAA published a Direct Final Rule to amend the definition of a light-sport aircraft (LSA) in two areas. The changes permit development of lighter-than-air (LTA) LSA, and allow retractable landing gear for LSA intended for operation on water.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2007-28335 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2007-28333 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Pub. L. 105- 383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2007-28331 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR part 388.

These special conditions are issued to Op Technologies, Inc.; 15236 NW., Greenbrier Parkway, Beaverton, OR 97006 for a Supplemental Type Certificate for the Cirrus Design Corporation Model SR22 airplane. This airplane will have novel and unusual design features when compared to the state of technology envisaged in the applicable airworthiness standards. These novel and unusual design features include the installation of electronic flight instrument system (EFIS) displays Model Pegasus Primary Flight Displays manufactured by Op Technologies for which the applicable regulations do not contain adequate or appropriate airworthiness standards for the protection of these systems from the effects of high intensity radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to the airworthiness standards applicable to these airplanes.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD 2007-28338 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.