Establishment of Class E Airspace; Granby, CO, 64014 [C1-2020-21888]
Download as PDF
<![CDATA[
64014
Federal Register / Vol. 85, No. 197 / Friday, October 9, 2020 / Rules and Regulations
issuance of Boeing Alert Requirements
Bulletin B787–81205–SB270044–00 RB, Issue
002, dated July 7, 2020. A review of airplane
maintenance records is acceptable in lieu of
this identification requirement, if the
software version can be conclusively
determined from that review.
(2) Identify the version of the DCA system
and MS software installed. If the installed
version is not DCA MS CBP4 or a laterapproved version of DCA MS software:
Within 6 months after the effective date of
this AD, install a new DCA system and MS
software and do a software check, in
accordance with the Accomplishment
Instructions of Boeing Alert Service Bulletin
B787–81205–SB310014, Issue 002, dated
June 14, 2017. Later-approved software
versions are only those Boeing software
versions that are approved as a replacement
for the applicable software, and are approved
as part of the type design by the FAA or The
Boeing Company ODA after issuance of
Boeing Alert Service Bulletin B787–81205–
SB310014, Issue 002, dated June 14, 2017.
(p) Credit for Previous Actions
This paragraph provides credit for actions
specified in paragraphs (n)(1) and (o)(1) of
this AD, if those actions were performed
before the effective date of this AD using
Boeing Alert Requirements Bulletin B787–
81205–SB270044–00 RB, Issue 001, dated
December 18, 2018.
(q) Terminating Action for Certain
Requirements of This AD
(1) Except as specified in paragraph (q)(2)
of this AD: Accomplishment of the actions
required by paragraph (n) or (o) of this AD,
as applicable, terminates the requirements of
paragraphs (g) through (m) of this AD.
(2) Accomplishment of the actions required
by paragraph (n) or (o) of this AD, as
applicable, terminates the requirements of
paragraph (k) of this AD for that airplane
only.
(3) Accomplishment of the actions required
by paragraph (n) or (o) of this AD, as
applicable, on all affected airplanes in an
operator’s fleet, and subsequent removal of
figure 1 to paragraph (k) of this AD from the
existing AFM, terminates the requirements of
paragraph (k) of this AD for the fleet. The
removal must be done no later than 6 months
after the effective date of this AD.
(r) Parts Installation Prohibition
As of the effective date of this AD,
installation on any airplane of FCE CBP
software with a version prior to CBP5 is
prohibited.
(s) Alternative Methods of Compliance
(AMOCs)
(1) The Manager, Seattle ACO Branch,
FAA, has the authority to approve AMOCs
for this AD, if requested using the procedures
found in 14 CFR 39.19. In accordance with
14 CFR 39.19, send your request to your
principal inspector or local Flight Standards
District Office, as appropriate. If sending
information directly to the manager of the
certification office, send it to the attention of
the person identified in paragraph (t)(1) of
this AD. Information may be emailed to: 9ANM-Seattle-ACO-AMOC-Requests@faa.gov.
VerDate Sep<11>2014
16:35 Oct 08, 2020
Jkt 253001
(2) Before using any approved AMOC,
notify your appropriate principal inspector,
or lacking a principal inspector, the manager
of the local flight standards district office/
certificate holding district office.
(3) An AMOC that provides an acceptable
level of safety may be used for any repair,
modification, or alteration required by this
AD if it is approved by The Boeing Company
ODA that has been authorized by the
Manager, Seattle ACO Branch, FAA, to make
those findings. To be approved, the repair
method, modification deviation, or alteration
deviation must meet the certification basis of
the airplane, and the approval must
specifically refer to this AD.
(4) AMOCs approved previously for AD
2015–14–07, AD 2016–07–10, and AD 2016–
24–09, are approved as AMOCs for the
corresponding provisions of paragraphs (g)
through (l) of this AD.
(7) For service information identified in
this AD, contact Boeing Commercial
Airplanes, Attention: Contractual & Data
Services (C&DS), 2600 Westminster Blvd.,
MC 110–SK57, Seal Beach, CA 90740–5600;
telephone 562–797–1717; internet https://
www.myboeingfleet.com.
(8) You may view this service information
at the FAA, Airworthiness Products Section,
Operational Safety Branch, 2200 South 216th
St., Des Moines, WA. For information on the
availability of this material at the FAA, call
206–231–3195.
(9) You may view this service information
that is incorporated by reference at the
National Archives and Records
Administration (NARA). For information on
the availability of this material at NARA,
email fedreg.legal@nara.gov, or go to: https://
www.archives.gov/federal-register/cfr/ibrlocations.html.
(t) Related Information
(1) For more information about this AD,
contact Maureen G. Fallon, Aerospace
Engineer, Systems and Equipment Section,
FAA, Seattle ACO Branch, 2200 South 216th
St., Des Moines, WA 98198; phone and fax:
206–231–3690; email: maureen.g.fallon@
faa.gov.
(2) Service information identified in this
AD that is not incorporated by reference is
available at the addresses specified in
paragraphs (u)(7) and (8) of this AD.
Issued on September 23, 2020.
Lance T. Gant,
Director, Compliance & Airworthiness
Division, Aircraft Certification Service.
(u) Material Incorporated by Reference
(1) The Director of the Federal Register
approved the incorporation by reference
(IBR) of the service information listed in this
paragraph under 5 U.S.C. 552(a) and 1 CFR
part 51.
(2) You must use this service information
as applicable to do the actions required by
this AD, unless this AD specifies otherwise.
(3) The following service information was
approved for IBR on November 13, 2020.
(i) Boeing Alert Requirements Bulletin
B787–81205–SB270044–00 RB, Issue 002,
dated July 7, 2020.
(ii) Boeing Alert Service Bulletin B787–
81205–SB310014, Issue 002, dated June 14,
2017.
(4) The following service information was
approved for IBR on June 6, 2019 (84 FR
18707, May 2, 2019).
(i) Boeing Alert Service Bulletin B787–
81205–SB270039–00, Issue 002, dated March
8, 2018.
(ii) [Reserved]
(5) The following service information was
approved for IBR on December 2, 2016 (81 FR
86912, December 2, 2016).
(i) Boeing Alert Service Bulletin B787–
81205–SB270040–00, Issue 001, dated
November 25, 2016.
(ii) [Reserved]
(6) The following service information was
approved for IBR on August 20, 2015 (80 FR
42014, July 16, 2015).
(i) Boeing Alert Service Bulletin B787–
81205–SB270017–00, Issue 001, dated
September 18, 2013.
(ii) Boeing Alert Service Bulletin B787–
81205–SB270020–00, Issue 002, dated
February 12, 2015.
(iii) Boeing Service Bulletin B787–81205–
SB270023–00, Issue 001, dated July 24, 2014.
14 CFR Part 71
PO 00000
Frm 00022
Fmt 4700
Sfmt 4700
[FR Doc. 2020–22236 Filed 10–8–20; 8:45 am]
BILLING CODE 4910–13–P
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
[Docket No. FAA–2020–0627; Airspace
Docket No. 19–ANM–29]
RIN 2120–AA66
Establishment of Class E Airspace;
Granby, CO
Correction
In the rule document 2020–21888
appearing on pages 62572–62573 in the
issue of Monday, October 5, 2020, make
the following correction:
§ 71.1
[Corrected]
1. On page 62573, in the second
column, line twenty, ‘‘2.2° miles’’
should read ‘‘2.2 miles’’
■ 2. On page 62573, in the second
column, line twenty-one, ‘‘110+
bearing’’ should read ‘‘110° bearing’’
■
[FR Doc. C1–2020–21888 Filed 10–8–20; 8:45 am]
BILLING CODE 1301–00–D
DEPARTMENT OF COMMERCE
Bureau of Industry and Security
15 CFR Part 744
[Docket No. 200831–0029]
RIN 0694–AI10
Revisions to the Unverified List (UVL)
Bureau of Industry and
Security, Commerce.
AGENCY:
E:\FR\FM\09OCR1.SGM
09OCR1
]]>Agencies
[Federal Register Volume 85, Number 197 (Friday, October 9, 2020)]
[Rules and Regulations]
[Page 64014]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: C1-2020-21888]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 71
[Docket No. FAA-2020-0627; Airspace Docket No. 19-ANM-29]
RIN 2120-AA66
Establishment of Class E Airspace; Granby, CO
Correction
In the rule document 2020-21888 appearing on pages 62572-62573 in
the issue of Monday, October 5, 2020, make the following correction:
Sec. 71.1 [Corrected]
0
1. On page 62573, in the second column, line twenty, ``2.2[deg] miles''
should read ``2.2 miles''
0
2. On page 62573, in the second column, line twenty-one, ``110[szlig]
bearing'' should read ``110[deg] bearing''
[FR Doc. C1-2020-21888 Filed 10-8-20; 8:45 am]
BILLING CODE 1301-00-D
