Addition of Entities to the Entity List, Revision of an Entry on the Entity List, and Removal of Entities From the Entity List, 66840 [C1-2019-24635]
Download as PDF
66840
Federal Register / Vol. 84, No. 235 / Friday, December 6, 2019 / Rules and Regulations
Adoption of the Amendment
Accordingly, under the authority
delegated to me by the Administrator,
the FAA amends 14 CFR part 39 as
follows:
PART 39—AIRWORTHINESS
DIRECTIVES
1. The authority citation for part 39
continues to read as follows:
■
Authority: 49 U.S.C. 106(g), 40113, 44701.
§ 39.13
[Amended]
2. The FAA amends § 39.13 by adding
the following new airworthiness
directive (AD):
■
2019–23–09 Bell Helicopter Textron
Canada Limited: Amendment 39–19803;
Docket No. FAA–2017–1105; Product
Identifier 2017–SW–023–AD.
(a) Applicability
This AD applies to Bell Helicopter Textron
Canada Limited Model 427 helicopters with
a vertical fin part number (P/N) 427–035–
840–105 or P/N 427–035–840–109 installed,
certificated in any category.
(b) Unsafe Condition
This AD defines the unsafe condition as a
crack on the vertical fin skin. This condition
could lead to structural failure of the fin,
separation of the skin from the helicopter,
damage to the main or tail rotor blades and
loss of helicopter control.
(c) Effective Date
This AD becomes effective January 10,
2020.
lotter on DSKBCFDHB2PROD with RULES
(d) Compliance
You are responsible for performing each
action required by this AD within the
specified compliance time unless it has
already been accomplished prior to that time.
(e) Required Actions
Within 25 hours time-in-service (TIS) or
before the helicopter has accumulated 1,500
hours TIS, whichever occurs later, and
thereafter at intervals not to exceed 100 hours
TIS:
(1) Remove the vertical fin and clean the
vertical fin attachment area with a soap
solution to remove all traces of dirt, stains,
exhaust residue, and oil. Rinse the area with
water and let dry.
(i) Using a 10X power magnifying glass,
visually inspect the inboard skin of the
vertical fin for a crack around the four
tailboom attachment points as depicted in
Figure 1 of Bell Helicopter Alert Service
Bulletin 427–15–38, Revision A, dated
November 14, 2016. Pay particular attention
to the upper aft attachment point.
(ii) If there is a crack, replace the vertical
fin before further flight.
(2) If the vertical fin does not have a serial
number, assign a serial number using the
helicopter serial number, and permanently
mark the new serial number on the vertical
fin data plate. Create a component history
card or equivalent record and annotate the
serial number.
VerDate Sep<11>2014
22:31 Dec 05, 2019
Jkt 250001
(f) Alternative Methods of Compliance
(AMOCs)
DEPARTMENT OF COMMERCE
(1) The Manager, Safety Management
Section, Rotorcraft Standards Branch, FAA,
may approve AMOCs for this AD. Send your
proposal to: Matt Fuller, Senior Aviation
Safety Engineer, Safety Management Section,
Rotorcraft Standards Branch, FAA, 10101
Hillwood Pkwy., Fort Worth, TX 76177;
telephone 817–222–5110; email 9-ASW-FTWAMOC-Requests@faa.gov.
(2) For operations conducted under a 14
CFR part 119 operating certificate or under
14 CFR part 91, subpart K, the FAA suggests
you notify your principal inspector, or
lacking a principal inspector, the manager of
the local flight standards district office or
certificate holding district office, before
operating any aircraft complying with this
AD through an AMOC.
Bureau of Industry and Security
(g) Additional Information
Supplement No. 4 to Part 744—Entity
List
The subject of this AD is addressed in
Transport Canada AD No. CF–2017–03, dated
January 31, 2017. You may view the
Transport Canada AD on the internet at
https://www.regulations.gov in Docket No.
FAA–2017–1105.
(h) Subject
Joint Aircraft Service Component (JASC)
Code: 55, Empennage Structure.
(i) Material Incorporated by Reference
(1) The Director of the Federal Register
approved the incorporation by reference of
the service information listed in this
paragraph under 5 U.S.C. 552(a) and 1 CFR
part 51.
(2) You must use this service information
as applicable to do the actions required by
this AD, unless the AD specifies otherwise.
(i) Bell Helicopter Alert Service Bulletin
427–15–38, Revision A, dated November 14,
2016.
(ii) [Reserved]
(3) For Bell Helicopter Textron Canada
Limited service information identified in this
AD, contact Bell Helicopter Textron Canada
Limited, 12,800 Rue de l’Avenir, Mirabel,
Quebec J7J1R4; telephone 450–437–2862 or
800–363–8023; fax 450–433–0272; or at
https://www.bellcustomer.com.
(4) You may view this service information
at FAA, Office of the Regional Counsel,
Southwest Region, 10101 Hillwood Pkwy.,
Room 6N–321, Fort Worth, TX 76177. For
information on the availability of this
material at the FAA, call 817–222–5110.
(5) You may view this service information
that is incorporated by reference at the
National Archives and Records
Administration (NARA). For information on
the availability of this material at NARA,
email fedreg.legal@nara.gov, or go to: https://
www.archives.gov/federal-register/cfr/ibrlocations.html.
Issued in Fort Worth, Texas, on November
19, 2019.
Lance T. Gant,
Director, Compliance & Airworthiness
Division, Aircraft Certification Service.
[FR Doc. 2019–26298 Filed 12–5–19; 8:45 am]
BILLING CODE 4910–13–P
PO 00000
Frm 00028
Fmt 4700
Sfmt 4700
15 CFR Part 744
[Docket No. 191105–0076]
RIN 0694–AH85
Addition of Entities to the Entity List,
Revision of an Entry on the Entity List,
and Removal of Entities From the
Entity List
Correction
In rule document 2019–24635
beginning on page 61538 in the issue of
Wednesday, November 13, 2019, make
the following corrections:
1. On page 61543, in the table, in the
fourth row under PAKISTAN, in the
rightmost column,
84 FR [INSERT FR PAGE NUMBER],
November 13, 2019.
should read
83 FR 12479, 3/22/18.
84 FR [INSERT FR PAGE NUMBER],
November 13, 2019.
■ 2. On the same page, in the table, in
the sixth row under PAKISTAN, in the
rightmost column,
84 FR [INSERT FR PAGE NUMBER],
November 13, 2019. Presumption of
denial.
should read
84 FR [INSERT FR PAGE NUMBER],
November 13, 2019.
■ 3. On page 61545, in the table, in the
fifth row under UNITED ARAB
EMIRATES, in the rightmost column,
84 FR [INSERT FR PAGE NUMBER].
should read
84 FR [INSERT FR PAGE NUMBER],
November 13, 2019.
■
[FR Doc. C1–2019–24635 Filed 12–5–19; 8:45 am]
BILLING CODE 1301–00–P
DEPARTMENT OF HOMELAND
SECURITY
Coast Guard
33 CFR Part 165
[Docket Number USCG–2019–0926]
RIN 1625–AA00
Safety Zone; Electrical Cable
Installation, Menominee River,
Menominee, MI and Marinette, WI
Coast Guard, DHS.
Temporary final rule.
AGENCY:
ACTION:
E:\FR\FM\06DER1.SGM
06DER1
Agencies
[Federal Register Volume 84, Number 235 (Friday, December 6, 2019)]
[Rules and Regulations]
[Page 66840]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: C1-2019-24635]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF COMMERCE
Bureau of Industry and Security
15 CFR Part 744
[Docket No. 191105-0076]
RIN 0694-AH85
Addition of Entities to the Entity List, Revision of an Entry on
the Entity List, and Removal of Entities From the Entity List
Correction
In rule document 2019-24635 beginning on page 61538 in the issue of
Wednesday, November 13, 2019, make the following corrections:
Supplement No. 4 to Part 744--Entity List
0
1. On page 61543, in the table, in the fourth row under PAKISTAN, in
the rightmost column,
84 FR [INSERT FR PAGE NUMBER], November 13, 2019.
should read
83 FR 12479, 3/22/18.
84 FR [INSERT FR PAGE NUMBER], November 13, 2019.
0
2. On the same page, in the table, in the sixth row under PAKISTAN, in
the rightmost column,
84 FR [INSERT FR PAGE NUMBER], November 13, 2019. Presumption of
denial.
should read
84 FR [INSERT FR PAGE NUMBER], November 13, 2019.
0
3. On page 61545, in the table, in the fifth row under UNITED ARAB
EMIRATES, in the rightmost column,
84 FR [INSERT FR PAGE NUMBER].
should read
84 FR [INSERT FR PAGE NUMBER], November 13, 2019.
[FR Doc. C1-2019-24635 Filed 12-5-19; 8:45 am]
BILLING CODE 1301-00-P