Foreign-Trade Zone 61-San Juan, Puerto Rico; Application for Subzone; Plaza Warehousing & Realty Corporation; Caguas, Puerto Rico, 44558 [2017-20402]
Download as PDF
<![CDATA[
asabaliauskas on DSKBBXCHB2PROD with NOTICES
44558
Federal Register / Vol. 82, No. 184 / Monday, September 25, 2017 / Notices
connections (air intake/exhaust transfer/
fuel block/turbo oil drain/water inlet/
water outlet/water transfer/injector fuel
supply); electronic control coolers; oil
coolers; covers (access hole/hand hole/
rocker lever/starter flange); valve
crossheads; viscous vibration dampers;
steel and rubber gaskets (accessory drive
support//carrier/cover plate/cylinder
head/gear housing/oil pan/oil transfer
connection/thermostat housing); gears
(camshaft/flywheel ring/hydraulic
pump/idler); electronic control module
wiring harnesses; wiring harnesses;
corrosion resistor heads; fuel filter
heads; lubricating oil filter heads; intake
air heaters; silicone rubber hump hoses;
silicone rubber hoses; housings
(flywheel/gear/oil cooler/rocker lever/
thermostat/thermostat top level
assembly); levers (cam follower/rocker/
rocker top level assembly); adjusting
links; air manifolds; exhaust manifolds;
fuel drain manifolds; ignition control
modules; oil pans; steel air inlet pipes;
exhaust outlet pipes; plates (clamping/
cooler/cover); flanged o-ring plugs;
threaded plugs; pulleys (accessory
drive/alternator/crankshaft/idler);
pumps (fuel transfer/lubricating oil/
water); injector fuel support connector
retainers; engine connecting rods; push
rods; valve rotators; rubber corrosion
resistor seals; rubber seals (flywheel
housing/front cover/gear housing/oil
cooler housing/oil filter head/rocker
level housing); sensors (engine speed/
humidity/position); shafts (gar accessory
drive/cam follower/idler/rocker lever);
steel injector sleeves; aluminum/steel/
nylon spacers; cylinder block stiffeners;
steel/aluminum/cast iron supports
(accessory/air compressor/alternator/
breather/camshaft/exhaust/recirculation
cooler/front engine/fuel pump/rocker
lever/thermostat housing); temperature
switches; steel tubes (compressor air
inlet/injector fuel supply/lubricating oil
suction/oil gauge/vent); turbocharger;
solenoid valves; and, aluminum exhaust
gas recirculation venturi (duty rates
range from free to 4.7%).
Public comment is invited from
interested parties. Submissions shall be
addressed to the Board’s Executive
Secretary at the address below. The
closing period for their receipt is
November 6, 2017.
A copy of the notification will be
available for public inspection at the
Office of the Executive Secretary,
Foreign-Trade Zones Board, Room
21013, U.S. Department of Commerce,
1401 Constitution Avenue NW.,
Washington, DC 20230–0002, and in the
‘‘Reading Room’’ section of the Board’s
Web site, which is accessible via
www.trade.gov/ftz.
VerDate Sep<11>2014
19:45 Sep 22, 2017
Jkt 241001
For further information, contact Diane
Finver at Diane.Finver@trade.gov or
(202) 482–1367.
For further information, contact
Camille Evans at Camille.Evans@
trade.gov or (202) 482–2350.
Dated: September 20, 2017.
Andrew McGilvray,
Executive Secretary.
Dated: September 20, 2017.
Andrew McGilvray,
Executive Secretary.
[FR Doc. 2017–20403 Filed 9–22–17; 8:45 am]
[FR Doc. 2017–20402 Filed 9–22–17; 8:45 am]
BILLING CODE 3510–DS–P
BILLING CODE 3510–DS–P
DEPARTMENT OF COMMERCE
DEPARTMENT OF COMMERCE
Foreign-Trade Zones Board
International Trade Administration
[C–533–874]
[S–147–2017]
Foreign-Trade Zone 61—San Juan,
Puerto Rico; Application for Subzone;
Plaza Warehousing & Realty
Corporation; Caguas, Puerto Rico
An application has been submitted to
the Foreign-Trade Zones Board (the
Board) by the Puerto Rico Trade and
Export Company, grantee of FTZ 61,
requesting subzone status for the facility
of Plaza Warehousing & Realty
Corporation located in Caguas, Puerto
Rico. The application was submitted
pursuant to the provisions of the
Foreign-Trade Zones Act, as amended
(19 U.S.C. 81a–81u), and the regulations
of the Board (15 CFR part 400). It was
formally docketed on September 20,
2017.
The proposed subzone (15.5 acres) is
´
located at Road #1, Km. 27.9, Barrio Rıo
˜
Canas, Caguas, Puerto Rico. No
authorization for production activity has
been requested at this time. The
proposed subzone would be subject to
the existing activation limit of FTZ 61.
In accordance with the Board’s
regulations, Camille Evans of the FTZ
Staff is designated examiner to review
the application and make
recommendations to the Executive
Secretary.
Public comment is invited from
interested parties. Submissions shall be
addressed to the Board’s Executive
Secretary at the address below. The
closing period for their receipt is
November 6, 2017. Rebuttal comments
in response to material submitted
during the foregoing period may be
submitted during the subsequent 15-day
period to November 20, 2017.
A copy of the application will be
available for public inspection at the
Office of the Executive Secretary,
Foreign-Trade Zones Board, Room
21013, U.S. Department of Commerce,
1401 Constitution Avenue NW.,
Washington, DC 20230–0002, and in the
‘‘Reading Room’’ section of the Board’s
Web site, which is accessible via
www.trade.gov/ftz.
PO 00000
Frm 00004
Fmt 4703
Sfmt 4703
Certain Cold-Drawn Mechanical Tubing
of Carbon and Alloy Steel From India:
Preliminary Affirmative Countervailing
Duty Determination
Enforcement and Compliance,
International Trade Administration,
Department of Commerce.
SUMMARY: The Department of Commerce
(the Department) preliminarily
determines that countervailable
subsidies are being provided to
producers and exporters of certain colddrawn mechanical tubing of carbon and
alloy steel (cold-drawn mechanical
tubing) from India. The period of
investigation is April 1, 2016, through
March 31, 2017.
DATES: Applied September 25, 2017.
FOR FURTHER INFORMATION CONTACT:
Ryan Mullen or Carrie Bethea, AD/CVD
Operations, Office V, Enforcement and
Compliance, International Trade
Administration, U.S. Department of
Commerce, 1401 Constitution Avenue
NW., Washington, DC 20230; telephone:
(202) 482–5260 or (202) 482–1491,
respectively.
AGENCY:
SUPPLEMENTARY INFORMATION:
Background
This preliminary determination is
made in accordance with section 703(b)
of the Tariff Act of 1930, as amended
(the Act). The Department published the
notice of initiation of this investigation
on May 16, 2017.1 On June 19, 2017, the
Department postponed the preliminary
determination of this investigation and
the revised deadline is now September
18, 2017.2 For a complete description of
the events that followed the initiation of
this investigation, see the Preliminary
1 See Certain Cold-Drawn Mechanical Tubing of
Carbon and Alloy Steel from India and the People’s
Republic of China: Initiation of Countervailing Duty
Investigations, 82 FR 22486 (May 16, 2017)
(Initiation Notice).
2 See Certain Cold-Drawn Mechanical Tubing of
Carbon and Alloy Steel from India and the People’s
Republic of China: Postponement of Preliminary
Determination in the Countervailing Duty
Investigations, 82 FR 28641 (June 23, 2017).
E:\FR\FM\25SEN1.SGM
25SEN1
]]>Agencies
[Federal Register Volume 82, Number 184 (Monday, September 25, 2017)]
[Notices]
[Page 44558]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2017-20402]
-----------------------------------------------------------------------
DEPARTMENT OF COMMERCE
Foreign-Trade Zones Board
[S-147-2017]
Foreign-Trade Zone 61--San Juan, Puerto Rico; Application for
Subzone; Plaza Warehousing & Realty Corporation; Caguas, Puerto Rico
An application has been submitted to the Foreign-Trade Zones Board
(the Board) by the Puerto Rico Trade and Export Company, grantee of FTZ
61, requesting subzone status for the facility of Plaza Warehousing &
Realty Corporation located in Caguas, Puerto Rico. The application was
submitted pursuant to the provisions of the Foreign-Trade Zones Act, as
amended (19 U.S.C. 81a-81u), and the regulations of the Board (15 CFR
part 400). It was formally docketed on September 20, 2017.
The proposed subzone (15.5 acres) is located at Road #1, Km. 27.9,
Barrio R[iacute]o Ca[ntilde]as, Caguas, Puerto Rico. No authorization
for production activity has been requested at this time. The proposed
subzone would be subject to the existing activation limit of FTZ 61.
In accordance with the Board's regulations, Camille Evans of the
FTZ Staff is designated examiner to review the application and make
recommendations to the Executive Secretary.
Public comment is invited from interested parties. Submissions
shall be addressed to the Board's Executive Secretary at the address
below. The closing period for their receipt is November 6, 2017.
Rebuttal comments in response to material submitted during the
foregoing period may be submitted during the subsequent 15-day period
to November 20, 2017.
A copy of the application will be available for public inspection
at the Office of the Executive Secretary, Foreign-Trade Zones Board,
Room 21013, U.S. Department of Commerce, 1401 Constitution Avenue NW.,
Washington, DC 20230-0002, and in the ``Reading Room'' section of the
Board's Web site, which is accessible via www.trade.gov/ftz.
For further information, contact Camille Evans at
Camille.Evans@trade.gov or (202) 482-2350.
Dated: September 20, 2017.
Andrew McGilvray,
Executive Secretary.
[FR Doc. 2017-20402 Filed 9-22-17; 8:45 am]
BILLING CODE 3510-DS-P
