Airworthiness Directives; Bombardier, Inc. Airplanes, 5365-5367 [2016-01741]
Agencies
[Federal Register Volume 81, Number 21 (Tuesday, February 2, 2016)] [Rules and Regulations] [Pages 5365-5367] From the Federal Register Online via the Government Publishing Office [www.gpo.gov] [FR Doc No: 2016-01741] ======================================================================== Rules and Regulations Federal Register ________________________________________________________________________ This section of the FEDERAL REGISTER contains regulatory documents having general applicability and legal effect, most of which are keyed to and codified in the Code of Federal Regulations, which is published under 50 titles pursuant to 44 U.S.C. 1510. The Code of Federal Regulations is sold by the Superintendent of Documents. Prices of new books are listed in the first FEDERAL REGISTER issue of each week. ======================================================================== Federal Register / Vol. 81, No. 21 / Tuesday, February 2, 2016 / Rules and Regulations [[Page 5365]] DEPARTMENT OF TRANSPORTATION Federal Aviation Administration 14 CFR Part 39 [Docket No. FAA-2015-3140; Directorate Identifier 2015-NM-063-AD; Amendment 39-18385; AD 2016-02-05] RIN 2120-AA64 Airworthiness Directives; Bombardier, Inc. Airplanes AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT). ACTION: Final rule. ----------------------------------------------------------------------- SUMMARY: We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model BD-100-1A10 (Challenger 300) airplanes. This AD was prompted by multiple reports of a short circuit between the heater element and the metal sheath of the pitot-static probe heater. This AD requires replacement of the left and right pitot-static probes with newly redesigned left and right pitot-static probes. We are issuing this AD to prevent degradation of the heating ability of the pitot- static probe heater, resulting in erroneous airspeed indication during flight in icing conditions and consequent reduced controllability of the airplane. DATES: This AD becomes effective March 8, 2016. The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of March 8, 2016. ADDRESSES: You may examine the AD docket on the Internet at https://www.regulations.gov/#!docketDetail;D=FAA-2015-3140; or in person at the Docket Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC. For service information identified in this final rule, contact Bombardier, Inc., 400 C[ocirc]te-Vertu Road West, Dorval, Qu[eacute]bec H4S 1Y9, Canada; telephone: 514-855-5000; fax: 514-855-7401; email: thd.crj@aero.bombardier.com; Internet https://www.bombardier.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. It is also available on the Internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2015-3140. FOR FURTHER INFORMATION CONTACT: Assata Dessaline, Aerospace Engineer, Avionics and Services Branch, ANE-172, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: 516-228-7301; fax: 516-794-5531. SUPPLEMENTARY INFORMATION: Discussion We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Bombardier, Inc. Model BD-100-1A10 (Challenger 300) airplanes. The NPRM published in the Federal Register on July 31, 2015 (80 FR 45617). Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian AD CF-2015-04, dated March 17, 2015 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for certain Bombardier, Inc. Model BD-100-1A10 (Challenger 300) airplanes. The MCAI states: There have been several reports where the pitot-static probe heater came on and remained on regardless of the heater control selected position. Investigation determined that the root cause is a short circuit between the heater element and the metal sheath. If not corrected, this condition may degrade the heating, resulting in erroneous Airspeed Indication when flying in icing condition [and consequent reduced controllability of the airplane]. This [Canadian] AD mandates the replacement of the pitot-static probes with a redesigned probe which will prevent this failure mode. You may examine the MCAI in the AD docket on the Internet at https://www.regulations.gov/#!documentDetail;D=FAA-2015-3140-0002. Comments We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (80 FR 45617, July 31, 2015) or on the determination of the cost to the public. Conclusion We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:Are consistent with the intent that was proposed in the NPRM (80 FR 45617, July 31, 2015) for correcting the unsafe condition; and Do not add any additional burden upon the public than was already proposed in the NPRM (80 FR 45617, July 31, 2015). Related Service Information Under 1 CFR Part 51 Bombardier issued Service Bulletin 100-34-38, dated January 9, 2014. The service information describes procedures for replacement of the left and right pitot-static probes with newly redesigned left and right pitot-static probes, part numbers 0856WC3 and 0856WC4 respectively. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section. Costs of Compliance We estimate that this AD affects 126 airplanes of U.S. registry. We also estimate that it will take about 12 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $13,468 per product. Based on these figures, we estimate the cost of this AD on U.S. operators to be $1,825,488, or $14,488 per product. According to the manufacturer, some of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we [[Page 5366]] have included all costs in our cost estimate. Authority for This Rulemaking Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority. We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. Regulatory Findings We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. For the reasons discussed above, I certify that this AD: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 3. Will not affect intrastate aviation in Alaska; and 4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. Examining the AD Docket You may examine the AD docket on the Internet at https://www.regulations.gov/#!docketDetail;D=FAA-2015-3140; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone: 800- 647-5527) is in the ADDRESSES section. List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. Adoption of the Amendment Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows: Authority: 49 U.S.C. 106(g), 40113, 44701. Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): 2016-02-05 Bombardier, Inc.: Amendment 39-18385. Docket No. FAA- 2015-3140; Directorate Identifier 2015-NM-063-AD. (a) Effective Date This AD becomes effective March 8, 2016. (b) Affected ADs None. (c) Applicability This AD applies to Bombardier, Inc. Model BD-100-1A10 (Challenger 300) airplanes, certificated in any category, serial numbers 20003 through 20500 inclusive. (d) Subject Air Transport Association (ATA) of America Code 34, Navigation. (e) Reason This AD was prompted by multiple reports of a short circuit between the heater element and the metal sheath of the pitot-static probe heater. We are issuing this AD to prevent degradation of the heating ability of the pitot-static probe heater, resulting in erroneous airspeed indication during flight in icing conditions and consequent reduced controllability of the airplane. (f) Compliance Comply with this AD within the compliance times specified, unless already done. (g) Replacement of Left and Right Pitot-Static Probes Within 24 months after the effective date of this AD, replace the left and right pitot-static probes with newly designed pitot- static probes, part numbers (P/N) 0856WC3 and 0856WC4 respectively, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 100-34-38, dated January 9, 2014. (h) Parts Installation Prohibition As of the effective date of this AD, no person may install a pitot-static probe, P/N 0856WC1 or 0856WC2, on any airplane. (i) Other FAA AD Provisions The following provisions also apply to this AD: (1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the New York ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: 516-228-7300; fax: 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/ certificate holding district office. The AMOC approval letter must specifically reference this AD. (2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO, ANE-170, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature. (j) Related Information Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian AD CF-2015-04, dated March 17, 2015, for related information. This MCAI may be found in the AD docket on the Internet at https://www.regulations.gov/#!documentDetail;D=FAA-2015-3140-0002. (k) Material Incorporated by Reference (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. (i) Bombardier Service Bulletin 100-34-38, dated January 9, 2014. (ii) Reserved. (3) For service information identified in this AD, contact Bombardier, Inc., 400 C[ocirc]te-Vertu Road West, Dorval, Qu[eacute]bec H4S 1Y9, Canada; telephone: 514-855-5000; fax: 514- 855-7401; email: thd.crj@aero.bombardier.com; Internet https://www.bombardier.com. (4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: https://www.archives.gov/federal-register/cfr/ibr-locations.html. [[Page 5367]] Issued in Renton, Washington, on January 20, 2016. Michael Kaszycki, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. 2016-01741 Filed 2-1-16; 8:45 am] BILLING CODE 4910-13-P
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
