August 19, 2015 – Federal Register Recent Federal Regulation Documents
Results 101 - 110 of 110
Changes in Flood Hazard Determinations
This notice lists communities where the addition or modification of Base Flood Elevations (BFEs), base flood depths, Special Flood Hazard Area (SFHA) boundaries or zone designations, or the regulatory floodway (hereinafter referred to as flood hazard determinations), as shown on the Flood Insurance Rate Maps (FIRMs), and where applicable, in the supporting Flood Insurance Study (FIS) reports, prepared by the Federal Emergency Management Agency (FEMA) for each community, is appropriate because of new scientific or technical data. The FIRM, and where applicable, portions of the FIS report, have been revised to reflect these flood hazard determinations through issuance of a Letter of Map Revision (LOMR), in accordance with Title 44, Part 65 of the Code of Federal Regulations (44 CFR part 65). The LOMR will be used by insurance agents and others to calculate appropriate flood insurance premium rates for new buildings and the contents of those buildings. For rating purposes, the currently effective community number is shown in the table below and must be used for all new policies and renewals.
Proposed Flood Hazard Determinations
Comments are requested on proposed flood hazard determinations, which may include additions or modifications of any Base Flood Elevation (BFE), base flood depth, Special Flood Hazard Area (SFHA) boundary or zone designation, or regulatory floodway on the Flood Insurance Rate Maps (FIRMs), and where applicable, in the supporting Flood Insurance Study (FIS) reports for the communities listed in the table below. The purpose of this notice is to seek general information and comment regarding the preliminary FIRM, and where applicable, the FIS report that the Federal Emergency Management Agency (FEMA) has provided to the affected communities. The FIRM and FIS report are the basis of the floodplain management measures that the community is required either to adopt or to show evidence of having in effect in order to qualify or remain qualified for participation in the National Flood Insurance Program (NFIP). In addition, the FIRM and FIS report, once effective, will be used by insurance agents and others to calculate appropriate flood insurance premium rates for new buildings and the contents of those buildings.
Proposed Amendment of Class D Airspace; Van Nuys, CA
This action proposes to amend Class D airspace and Class E surface area airspace at Van Nuys Airport, Van Nuys, CA. After reviewing the airspace, the FAA found the need to increase the Class D airspace and Class E surface areas for the safety and management of Instrument Flight Rules (IFR) operations for arriving and departing aircraft at the airport. The geographic coordinates of the satellite airports also would be adjusted for Class D airspace and Class E surface area airspace as well as noting a name change for Burbank- Glendale-Pasadena Airport.
Proposed Revocation of Class E Airspace; Burbank, CA
This action proposes to remove Class E surface area airspace designated as an extension to the Class C airspace at Burbank-Glendale- Pasadena Airport, Burbank, CA. After reviewing the airspace, the FAA found no standard instrument approach procedures requiring Class E surface area airspace designated as an extension to the Class C airspace.
Airworthiness Directives; The Boeing Company Airplanes
We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 airplanes. This proposed AD was prompted by reports of hydraulic contamination of the power control unit (PCU) electro-hydraulic servo valves (EHSVs) used in the flight control system; this contamination caused a restriction in the EHSVs resulting in the display of status messages from the engine indication and crew alerting system (EICAS). This proposed AD would require installing markers to limit the hydraulic system fluid used to a specific brand, doing hydraulic fluid tests of the hydraulic systems, replacing hydraulic system fluid if necessary, and doing all applicable related investigative and corrective actions. We are proposing this AD to prevent the failure of flight control hydraulic PCUs, which could lead to reduced controllability of the airplane.
Airworthiness Directives; The Boeing Company Airplanes
We propose to adopt a new airworthiness directive (AD) for all The Boeing Company Model 757 airplanes. This proposed AD was prompted by a report of cracking in the fuselage frame at a certain location. This proposed AD would require inspections for cracking in the fuselage frame, left and right sides, and repair if necessary. We are proposing this AD to detect and correct fuselage frame fatigue cracking that could result in loss of structural integrity and the inability to sustain loading conditions.
Hearings of the Judicial Conference Advisory Committees on the Federal Rules of Bankruptcy Procedure and the Federal Rules of Evidence
The Advisory Committees on the Federal Rules of Bankruptcy Procedure and the Federal Rules of Evidence have proposed amendments to the following rules: Bankruptcy Rules 1001 and 1006. Evidence Rules 803 and 902. The text of the proposed rules amendments and the accompanying Committee Notes can be found at the United States Federal Courts' Web site at: https://www.uscourts.gov/rules-policies/proposed-amendments- published-public-comment. All written comments and suggestions with respect to the proposed amendments may be submitted on or after the opening of the period for public comment on August 14, 2015, but no later than February 16, 2016. Written comments must be submitted electronically, following the instructions provided at the Web site address provided above. In accordance with established procedures, all comments submitted are available for public inspection. Public hearings are scheduled to be held on these proposed amendments as follows: Bankruptcy Rule 1006 in Washington, DC, on January 22, 2016, and in Pasadena, CA, on January 29, 2016; Rules of Evidence 803 and 902 in Phoenix, AZ, on January 6, 2016, and in Washington, DC, on February 12, 2016. Those wishing to testify should contact the Secretary at the address below in writing at least 30 days before the hearing.
Methane Sulfonic Acid; Exemption from the Requirement of a Tolerance
This regulation establishes an exemption from the requirement of a tolerance for residues of methane sulfonic acid (CAS Reg. No.75- 75-2) when used as an inert ingredient (acidifying agent) in pesticide formulations applied to animals at a maximum concentration not to exceed 3% by weight and when used as an inert ingredient in antimicrobial pesticide formulations applied to food-contact surfaces in public eating places, dairy-processing equipment, and food- processing equipment and utensils at a concentration not to exceed 5,000 parts per million (ppm). Lewis & Harrison, on behalf of BASF Corporation, submitted a petition to EPA under the Federal Food, Drug, and Cosmetic Act (FFDCA), requesting establishment of an exemption from the requirement of a tolerance. This regulation eliminates the need to establish a maximum permissible level for residues of methane sulfonic acid.
Energy Conservation Program: Energy Conservation Standards for Refrigerated Bottled or Canned Beverage Vending Machines
The Energy Policy and Conservation Act of 1975 (EPCA), as amended, prescribes energy conservation standards for various consumer products and certain commercial and industrial equipment, including refrigerated bottled or canned beverage vending machines (beverage vending machine). EPCA also requires the U.S. Department of Energy (DOE) to periodically determine whether more-stringent, amended standards would be technologically feasible and economically justified, and would save a significant amount of energy. In this NOPR, DOE proposes amended energy conservation standards for Class A and Class B beverage vending machines. DOE is also proposing to amend the definition for Class A equipment to more clearly differentiate Class A and Class B equipment, as well as to amend the definition of combination vending machine. In addition, DOE proposes to establish definitions and new energy conservations standards for Combination A and Combination B classes of beverage vending machines. This NOPR also announces a public meeting to receive comment on these proposed standards and associated analyses and results, and announces the availability of the NOPR technical support document (TSD).
Phosphoric Acid Manufacturing and Phosphate Fertilizer Production RTR and Standards of Performance for Phosphate Processing
This action finalizes the residual risk and technology review conducted for the Phosphoric Acid Manufacturing and Phosphate Fertilizer Production source categories regulated under national emission standards for hazardous air pollutants (NESHAP). In addition, this action finalizes an 8-year review of the current new source performance standards (NSPS) for five source categories. We are also taking final action addressing Clean Air Act (CAA) provisions related to emission standards for hazardous air pollutants, review and revision of emission standards, and work practice standards. The final amendments to the Phosphoric Acid Manufacturing NESHAP include: Numeric emission limits for previously unregulated mercury (Hg) and total fluoride emissions from calciners; work practice standards for hydrogen fluoride (HF) emissions from previously unregulated gypsum dewatering stacks and cooling ponds; clarifications to the applicability and monitoring requirements to accommodate process equipment and technology changes; removal of the exemptions for startup, shutdown, and malfunction (SSM); adoption of work practice standards for periods of startup and shutdown; and revised recordkeeping and reporting requirements for periods of SSM. The final amendments to the Phosphate Fertilizer Production NESHAP include: Clarifications to the applicability and monitoring requirements to accommodate process equipment and technology changes; removal of the exemptions for SSM; adoption of work practice standards for periods of startup and shutdown; and revised recordkeeping and reporting requirements for periods of SSM. The revised NESHAP for Phosphoric Acid Manufacturing facilities will mitigate future increases of Hg emissions from phosphate rock calciners by requiring pollution prevention measures. Further, based on the 8-year review of the current NSPS for these source categories, the EPA determined that no revisions to the numeric emission limits in those rules are warranted.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
