July 16, 2013 – Federal Register Recent Federal Regulation Documents

The Commodity Futures Trading Commission is correcting a final rule that appeared in the Federal Register of May 31, 2013 (78 FR 32866). The final rule adopted regulations, under the Dodd-Frank Wall Street Reform and Consumer Protection Act, defining the criteria for grouping swaps into separate swap categories and establishing methodologies for setting appropriate minimum block sizes for each swap category. These corrections fix errors in certain contract descriptions, block sizes, and block units listed in Appendix F to the final rule.

The Coronado National Forest is proposing to add the Portal CCC House and Portal Bunkhouse into the recreation rental program. The proposal is to charge $125.00 per night at the Portal CCC House and $100.00 per night at the Portal Bunkhouse. The Portal CCC House has two bedrooms (one with a futon couch, the second with a set of bunk beds), a single bathroom (with a shower), a small dining/living room combination, and a fully-equipped kitchen. It can accommodate up to five people. The Portal Bunkhouse has one bedroom (with a set of bunk beds and a small rollaway bed), a single bathroom (with a shower), and a small kitchen/dining room combination. It can accommodate up to four people. Both facilities have electric lights, heat, and running water. Other cabin rentals on National Forests in Arizona have shown the public appreciates the enhanced recreational opportunity afforded by these rehabilitated historic structures. Revenues from the rentals will be used for the continued operation and maintenance of this facility and other properties in the Arizona ``Rooms with a View'' Cabin Rental Program.

This notice amends the notice of a major disaster declaration for the State of Illinois (FEMA-4116-DR), dated May 10, 2013, and related determinations.

The Civilian Agency Acquisition Council and the Defense Acquisition Regulations Council (Councils) are seeking information that will assist in determining if there is a distinction between leasing and renting that is useful for the purposes stated in the Federal Acquisition Regulation (FAR). This Request for Information (RFI) does not address real property or its leasing.

The Department of the Treasury, as part of its continuing effort to reduce paperwork and respondent burden, invites the general public and other Federal agencies to take this opportunity to comment on proposed and/or continuing information collections, as required by the Paperwork Reduction Act of 1995, Public Law 104-13 (44 U.S.C. 3506(c)(2)(A)). Currently, the IRS is soliciting comments regulations governing practice before the Internal Revenue.

In accordance with the Federal Advisory Committee Act, Public Law 92-463, as amended, the National Aeronautics and Space Administration announce a meeting for the Information Technology Infrastructure Committee (ITIC) of the NASA Advisory Council (NAC). This Committee reports to the NAC.

The Department of Labor, as part of its continuing effort to reduce paperwork and respondent burden, conducts a preclearance consultation program to provide the general public and federal agencies with an opportunity to comment on proposed and/or continuing collections of information in accordance with the Paperwork Reduction Act of 1995 (PRA95) [44 U.S.C. 3506(c)(2)(A)]. This program helps to ensure that requested data can be provided in the desired format, reporting burden (time and financial resources) is minimized, collection instruments are clearly understood, and the impact of collection requirements on respondents can be properly assessed. Currently, the Employment and Training Administration is soliciting comments concerning the collection of data about the proposed extension of the Benefits Timeliness and Quality (BTQ) data collection system, which is part of the Unemployment Insurance (UI) Performs measurement system (current expiration date is February 28, 2014). A copy of the proposed information collection request (ICR) can be obtained by contacting the office listed below in the addressee section of this notice.

Pursuant to section 10(a)(2) of the Federal Advisory Committee Act (5 U.S.C. App.), notice is hereby given that the Federal Council on the Arts and the Humanities will hold a meeting of the Arts and Artifacts Domestic Indemnity Panel. The purpose of the meeting is for panel review, discussion, evaluation, and recommendation of applications for Certificates of Indemnity submitted to the Federal Council on the Arts and the Humanities, for exhibitions beginning on or after October 1, 2013.

The United States Department of Commerce, International Trade Administration

We are publishing a new airworthiness directive (AD) for Eurocopter France Model AS350B, AS350BA, AS350B1, AS350B2, AS350B3, AS350C, AS350D, AS350D1, AS355E, AS355F, AS355F1, AS355F2, AS355N, and AS355NP helicopters. This AD requires, before further flight, determining whether a single hydraulic main or tail rotor servo-control is installed on your helicopter. If a certain servo-control is installed, before the further flight, this AD requires replacing that servo-control. This AD was prompted by the discovery of excessive axial play detected on bearings installed on certain single hydraulic main and tail rotor servo-controls (servo-control). The excessive play could cause the distributor slide valve to jam in its sleeve. This condition could result in jamming the hydraulic flight controls, necessitating that the pilot cut off hydraulic power. This action would increase the pilot's workload, resulting in possible loss of helicopter control.

We are superseding airworthiness directive (AD) 87-02-07, which applied to all The Boeing Company Model 737-100 and -200 series airplanes. AD 87-02-07 required replacement of certain underwing fuel tank access covers with stronger, fire-resistant covers. This new AD also requires inspecting fuel tank access doors to determine that impact-resistant access doors are installed in the correct locations, inspecting application of stencils and index markers of impact- resistant access doors, doing corrective actions if necessary, revising the maintenance program, and adding airplanes to the applicability. This AD was prompted by reports of standard access doors installed where impact-resistant access doors are required, and reports of impact-resistant doors without stencils. We are issuing this AD to prevent foreign object penetration of the wing tank, which could lead to a fuel leak near ignition sources (engine, hot brakes), consequently leading to a fuel-fed fire.

We are superseding an existing airworthiness directive (AD) for certain The Boeing Company Model 767 airplanes. That AD currently requires sealing certain fasteners and stiffeners in the fuel tank, changing certain wire bundle clamp configurations on the fuel tank walls, inspecting certain fasteners in the fuel tanks and determining the method of attachment of the vortex generators; and performing corrective actions if necessary. This new AD adds a general visual inspection for the presence of a polytetrafluoroethylene (TFE) sleeve at the clamp location on the rear spar, and installation of a TFE sleeve if necessary. This new AD also adds airplanes to the applicability. This AD was prompted by fuel system reviews conducted by the manufacturer, and the identification of another possible ignition source location. We are issuing this AD to prevent possible ignition sources in the auxiliary (center) fuel tank, main fuel tanks, and surge tanks caused by a wiring short or lightning strike, which could result in fuel tank explosions and consequent loss of the airplane.