April 15, 2013 – Federal Register Recent Federal Regulation Documents

This proposed rule would establish the quantity of spearmint oil produced in the Far West, by class, that handlers may purchase from, or handle on behalf of, producers during the 2013-2014 marketing year, which begins on June 1, 2013. This proposal invites comments on the establishment of salable quantities and allotment percentages for Class 1 (Scotch) spearmint oil of 1,344,858 pounds and 65 percent, respectively, and for Class 3 (Native) spearmint oil of 1,432,189 pounds and 61 percent, respectively. The Spearmint Oil Administrative Committee (Committee), the agency responsible for local administration of the marketing order for spearmint oil produced in the Far West, recommended these limitations for the purpose of avoiding extreme fluctuations in supplies and prices to help maintain stability in the spearmint oil market.

This notice sets forth the dates of meetings of the Fort Hancock 21st Century Advisory Committee occurring in 2013.

As part of its mission to protect human health and the environment, the Environmental Protection Agency (EPA) publishes protective action guides to help federal, state, local and tribal emergency response officials make radiation protection decisions during emergencies. EPA, in coordination with a multi-agency working group within the Federal Radiological Preparedness Coordinating Committee (FRPCC), is proposing updates to the 1992 Manual of Protective Action Guides and Protective Actions for Nuclear Incidents, referred to as ``The 1992 PAG Manual'' (EPA 400-R-92-001, May 1992). The updated guidance in this revised 2013 PAG ManualProtective Action Guides and Planning Guidance for Radiological Incidents (``2013 PAG Manual'' hereafter) applies the PAGs to incidents other than just nuclear power plant accidents, updates the radiation dosimetry and dose calculations based on current science and incorporates late phase guidance. While there is no drinking water PAG provided in the proposal, the Agency continues to seek input on this. The newly proposed 2013 PAG Manual is available for interim use and review at www.regulations.gov.

This action modifies low-altitude RNAV route T-266 in the state of Alaska by removing two non-directional beacons (NDB) as the navigation signal source for segments of the route and replacing them with RNAV waypoints. This action enhances the safety and efficiency of the National Airspace System (NAS).

We are superseding an existing airworthiness directive (AD) for certain Airbus Model A319, A320, and A321 series airplanes. That AD currently requires installing spacer assemblies at the attachment points of the YZ-latches of the cargo loading system (CLS) in the forward and aft cargo compartments, as applicable. This new AD also requires modifying the attachment points of fixed YZ-latches of the CLS lower deck cargo holds on those airplanes on which one or both lower deck cargo holds have not been modified, which terminates the existing requirements. This AD was prompted by results from tests that have shown that the attachment points of the YZ-latches of the cargo loading system (CLS) fail under maximum loads and reports that installation has been applied only on one of the lower deck cargo holds, instead of on both forward and aft cargo holds, and that some airplanes could have installed the affected YZ-latches through the instructions of the cargo conversion manual. We are issuing this AD to prevent failure of the attachment points of the YZ-latches, which could result in unrestrained cargo causing damage to the fire protection system, hydraulic system, electrical wiring, or other equipment located in the forward and aft cargo compartments. This damage could adversely affect the continued safe flight of the airplane.

We are adopting a new airworthiness directive (AD) for certain International Aero Engines AG (IAE), V2525-D5 and V2528-D5 turbofan engines, with a certain No. 4 bearing internal scavenge tube and a certain No. 4 bearing external scavenge tube installed. This AD was prompted by a report of an engine under-cowl fire and commanded in- flight shutdown. This AD would require replacement of certain part number (P/N) No. 4 bearing internal scavenge tubes, and alignment checks of certain P/N No. 4 bearing external scavenge tubes. We are issuing this AD to prevent engine fire and damage to the airplane.

This notice announces the intention of the Agency for Healthcare Research and Quality (AHRQ) to request that the Office of Management and Budget (OMB) approve the proposed information collection project: ``Evaluating the Knowledge and Educational Needs of Students of Health Professions on Patient-Centered Outcomes Research.'' In accordance with the Paperwork Reduction Act, 44 U.S.C. 3501-3521, AHRQ invites the public to comment on this proposed information collection. This proposed information collection was previously published in the Federal Register on January 28th, 2013 and allowed 60 days for public comment. No substantive comments were received. The purpose of this notice is to allow an additional 30 days for public comment.

We are superseding an existing airworthiness directive (AD) for certain The Boeing Company Model 777-200, -200LR, -300, and -300ER series airplanes. That AD currently requires inspecting for scribe lines in the skin along lap joints, butt joints, certain external doublers, and the large cargo door hinges, and doing related investigative and corrective actions if necessary. This new AD adds an inspection for scribe lines where external decals have been applied or removed across lap joints, large cargo door hinges, and external doublers, and related investigative and corrective actions if necessary. This AD was prompted by a determination that scribe lines could occur where external decals are installed or removed across lap joints, large cargo door hinges, or external doublers. We are issuing this AD to detect and correct scribe lines, which can develop into fatigue cracks in the skin. Undetected fatigue cracks can grow and cause sudden decompression of the airplane.

We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 737-700, -700C, -800, and -900ER series airplanes, Model 747-400F series airplanes, and Model 767-200 and -300 series airplanes. This AD was prompted by reports indicating that certain crew oxygen mask stowage box units were possibly delivered with a burr in the inlet fitting. The burr might break loose during test or operation, and might pose an ignition source or cause an inlet valve to jam. This final rule adds a step to identify and label certain crew oxygen mask stowage box units that have already been inspected and reworked by the supplier, and allows operators to install new or serviceable crew oxygen mask stowage box units, and requires a general visual inspection for affected serial numbers of the crew oxygen mask stowage box units, and replacement or re-identification as necessary. We are issuing this AD to prevent an ignition source, which could result in an oxygen-fed fire; or an inlet valve jam in a crew oxygen mask stowage box unit, which could result in restricted flow of oxygen.

On September 13, 2010, FEMA published in the Federal Register a proposed rule that contained an erroneous table. On December 10, 2012, a correction to that original notice was published in the Federal Register. This notice provides corrections to that initial table and the correction notice, to be used in lieu of the information published at 75 FR 55515 and 77 FR 73394. The table provided here represents the flooding sources, location of referenced elevations, effective and modified elevations, and communities affected for Mercer County, Pennsylvania (All Jurisdictions). Specifically, it addresses the following flooding sources: Baker Run, Little Shenango River, Munnell Run, Neshannock Creek, Otter Creek, Sawmill Run, Shenango River, and Wolf Creek.

We are adopting a new airworthiness directive (AD) for Diamond Aircraft Industries GmbH Models DA 42, DA 42 M-NG, and DA 42NG airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as overextension of the main landing gear (MLG) shock absorber that could lead to the MLG jamming in the gear bay and result in damage to the aircraft or occupant injury. We are issuing this AD to require actions to address the unsafe condition on these products.