April 14, 2008 – Federal Register Recent Federal Regulation Documents

The FAA is superseding an existing airworthiness directive (AD), which applies to certain Airbus Model A318, A319, A320, and A321 airplanes. That AD currently requires repetitive inspections for cracking in the forward lug of the support rib 5 fitting of both main landing gear (MLG), and repair if necessary. The existing AD also provides optional terminating actions for certain airplanes, as well as other optional methods for complying with the inspection requirements of the existing AD. This new AD continues to require repetitive inspections for cracking in the forward lug of the support rib 5 fitting of the left and right MLG at new repetitive intervals in accordance with new service information, and repair or replacement of any cracked MLG fitting if necessary. This new AD also requires modification of the rib bushings of the left and right MLG, which would end the repetitive inspections. This AD results from cracks found in the forward lug of the MLG support rib 5 fitting. We are issuing this AD to prevent cracking in the forward lug of the MLG, which could result in failure of the lug and consequent collapse of the MLG during takeoff or landing.

We are adopting a new airworthiness directive (AD) for all Boeing Model 727 airplanes. This AD requires repetitive inspections for cracking or corrosion of the threaded end of the lower segment of the main landing gear (MLG) side strut, and corrective actions if necessary. This AD also requires prior or concurrent inspection for cracking or corrosion of the threads and thread relief area of the lower segment, corrective action if necessary, and re-assembly using corrosion inhibiting compound. This AD results from reports of the threads cracking on the MLG side strut lower segment. We are issuing this AD to prevent a fractured side strut, which could result in collapse of the MLG.

The FAA is superseding three existing airworthiness directives (ADs) for McCauley Propeller Systems propeller models B5JFR36C1101/ 114GCA-0, C5JFR36C1102/L114GCA-0, B5JFR36C1103/114HCA-0, and C5JFR36C1104/L114HCA-0. Those ADs currently require fluorescent penetrant inspections (FPI) and eddy current inspections (ECI) of propeller blades for cracks, and if any crack indications are found, removing the blade from service. This AD requires the same initial inspections, but extends the compliance times and intervals, adds repetitive inspections, and mandates a life limit for the blades. This AD results from our determination that we must require repetitive inspections for cracks, and from reports of blunt leading edges of the propeller blades due to erosion. We are issuing this AD to detect cracks in the propeller blade that could cause failure and separation of the propeller blade and loss of control of the airplane, and to detect blunt leading edges on the propeller blades, which could cause airplane single engine climb performance degradation and could result in an increased risk of collision with terrain.